Sika AnchorFix-1 High Strength Adhesive Anchoring System - 10.1 Fluid Ounce Cartridge

Sika AnchorFix-1 adhesive anchoring system has been specially formulated as a high-performance, two component adhesive anchor system for threaded and reinforcing bars in un-cracked concrete. Sika AnchorFix-1 is fast curing, used with standard caulking guns, can be used at low temperatures, has a high load capacity, is non-sag, even overhead. is a styrene-free polyester resin and low waste.

Applications

As a fast curing anchoring adhesive for all grades of:

• rebars
• reinforcing steel
• threaded rods
• bolts and special fastening systems

Can be used on:

• uncracked concrete
• solid masonry
• hard natural stone*
• solid rock*

* These substrates may vary greatly, in particular with regard to strength, composition and porosity. Therefore, for each application the suitability of Sika AnchorFix-1 Adhesive must be tested by first applying Sika AnchorFix-1 Adhesive only to a sample area. Check in particular bond strength, surface staining and discoloration.

Limitations

THE NTSB HAS STATED THAT THIS PRODUCT IS APPROVED FOR SHORT TERM LOADS ONLY AND SHOULD NOT BE USED IN SUSTAINED TENSILE LOAD ADHESIVE ANCHORING APPLICATIONS WHERE ADHESIVE FAILURE COULD RESULT IN A PUBLIC SAFETY RISK. CONSULT A DESIGN PROFESSIONAL PRIOR TO USE. The design professional on the job is ultimately responsible for the interpretation of the data provided on the product data sheet.